User guide

Chapter 3 - Loading the Software

Multi-Tech Systems, Inc. MultiVOIP User Guide

Chapter 3 - Loading the Software

The following installation procedures do not provide every screen or option in the process of

installing the MultiVOIP software. It is assumed that a technical person with a thorough

knowledge of Windows and the software loading process is doing the installation. Additional

information on the MultiVOIP software is provided in Chapter 4 and in the online Help.

The software loads a default configuration. Chapter Your Host MultiVOIP is configured with

default parameters as involves software loading and configuration.

If you are installing a MultiVOIP behind a firewall, add the following UDP ports to your firewall.

900 Signaling Information

5000 Status Information

5004 RTP Packets

5005 RTCP Packets

Refer to your firewall user documentation to enter and open these ports.

1. Verify that your MultiVOIP 100 has been properly cabled, that the power is turned on,

and that the Boot LED is off.

Note: If the Ethernet connection is not active, none of the LEDs will be on after

booting. This unit does not have a Power LED.

2. Insert the MultiVOIP 100 CD into your CD-ROM drive. The CD should start

automatically. It may take 10 to 20 seconds for the Multi Tech CD installation window

to display.

If the Multi-Tech Installation CD window does not display automatically, click My Computer,

then right click the CD ROM drive icon, click Open, and then click the Autorun icon.

3. When the Multi-Tech Installation CD dialog box displays, click the Install Software

icon.

3a. Click Install Software.

3b. Click Proprietary, and then click OK.