User guide

Chapter 2 - Installation

Multi-Tech System’s Inc. MultiVOIP User Guide

Cabling the Host MultiVOIP

Cabling your MultiVOIP involves making the proper Power, Command Port, and Internet

connections. The figure below shows the back panel connectors and the associated cable

connections.

POWER ETHERNET COMMAND PHONE

Cable Connections

Cabling Procedure

1. Using the supplied cable, connect the power supply to a live AC outlet, then plug the

power supply into the MultiVOIP as shown above.

2. Connect the MultiVOIP to a PC using the RJ-45 to DB9 (female) cable provided with

your unit. Plug the RJ-45 end of the cable into the Command port of the MultiVOIP

and connect the other end to the PC serial port you are using.

3. Connect a network cable to the Ethernet connector on the back of the MultiVOIP.

Connect the other end of the cable to your network.

4. If you are connecting a PSTN or PBX/FXO port to your MultiVOIP, connect one end

of an RJ-11 cable to the Phone connector on the back of the MultiVOIP and the other

end to the PSTN or PBX/FXO port.

5. Turn on power to the MultiVOIP by moving the power switch on the right side panel to

the ON position. Wait for the Boot LED on the MultiVOIP to go off before proceeding.

This may take a few minutes.

Note: If the Ethernet connection is not active, none of the LEDs will be on after

booting. This unit does not have a Power LED.