User guide

Multi-Tech System’s Inc. MultiVOIP User Guide
Chapter 1 - Introduction and Description
13
Back Panel Description
The cable connections for the MultiVOIP are made at the back panel. Connectors include
Power, Command Port (RS232), Ethernet (10BASE-T), and the Voice/Fax Channel. The
cable connectors are shown below and defined in the following groups.
Power
Connector
Command
Port (RJ-45)
Connector
Ethernet
(10BaseT)
Connector
Phone
(RJ-11)
Connector
POWER ETHERNET COMMAND PHONE
MVP120 Back Panel
Power Connector
The Power connector is used to connect the power transformer to the MultiVOIP.
Ethernet Connector
The Ethernet connector is used to connect the MultiVOIP to a LAN using unshielded twisted
cable. This connector is an RJ-45 jack.
Command Connector
The Command connector is used to configure the MultiVOIP using a PC with an available
serial port and running Windows® software. The Command connector is an RJ-45 jack, and
an adapter cable is provided to convert to a standard serial port DB9 female connector.
Phone Connector
Connects the Voice/Fax Channel to a PSTN or PBX/FXO port. This connector is an RJ-11
jack.