User guide

Configuring the Client MultiVOIPs

If you are installing a MultiVOIP behind a firewall, you need to

add the following UDP ports to your firewall.

900 Signaling Information 5004 RTP Packets

5000 Status Information 5005 RTCP Packets

Refer to your firewall user documentation to enter and open

these ports.

1. Disconnect the PC from the command port of the Host

MultiVOIP and connect it to the command port on the

Client MultiVOIP.

2. From your desktop, click Start | Programs I MultiVOIP I

Upgrade Software. The following dialog box displays.

3. Click Yes. The IP Protocol Default Setup dialog box

displays.

The default Frame Type is TYPE_II. If this does not

match your IP network, select the Frame Type from the

Frame Type list. The Frame Type choices are TYPE_II

and SNAP.