User guide

Software Installation

This section covers software installation. Additional information

on the MultiVOIP software is provided in the User Guide

supplied with your MultiVOIP.

Note: If you are installing a MultiVOIP behind a firewall, you

need to add the following UDP ports to your firewall.

900 Signaling Information 5004 RTP Packets

5000 Status Information 5005 RTCP Packets

Refer to your firewall user documentation to enter and open

these ports.

1. Make certain that your MVP120 has been properly cabled

and that the power is turned on.

Note: If the Ethrenet connection is not active, none of the

LEDs will be on after booting. This unit does not have a

Power LED.

2. Insert the MVP120 CD into your CD-ROM drive. The CD

should start automatically. It may take 10 to 20 seconds

for the installation window to display.