User guide

MultiVOIP Quick Start Guide

2. Connect the MultiVOIP to a PC using the RJ-45 to DB9

(female) cable provided with your unit. Plug the RJ-45 end

of the cable into the Command port of the MultiVOIP and

connect the other end to the PC serial port you are using.

See Figure 3.

3. Connect a network cable to the Ethernet connector on the

back of the MultiVOIP. Connect the other end of the cable

to your network.

4. Connect an RJ-11 cable to the Voice/Fax Channel

connector on the back of the MultiVOIP and the other end

to the PSTN or FXO/PBX port.

5. Turn on power to the MultiVOIP by setting the power

switch on the right side panel to the On position. Wait for

the Boot LED on the MultiVOIP to go off before

proceeding. This may take a couple of minutes.

Note: If the Ethernet connection is not active, none of the

LEDs will be on after booting. This unit does not have a

Power LED.