User guide

52
Chapter 5 - Remote Configuration and Management
Verify that the Communication Type is set for COM Port and the Select Port box is set for
the COM port of your local PC.
In the Dial String box, enter the AT command for dialing (ATDT) plus the phone number of the
remote MultiVOIP.
If your Modem Initialization String, Initialization Response, or Connect Response values are
different than the defaults in the dialog box, refer to your modem user documentation and
change the default values to match your modem.
Click OK when you are satisfied with your selections.
6. Run the MultiVOIP Configuration program. Click Start | Programs | MultiVOIP 100 |
MultiVOIP Configuration, or double-click the MultiVOIP Configuration icon in the program
group.
7. The Dialing dialog box displays while software is dialing the remote modem.
8. The Reading Setup dialog box displays.
9. The MultiVOIP 100 Setup menu displays. This is the dialog box of the remote MultiVOIP.
Refer to the online Help provided with your software for a description of each dialog box and
box within a dialog box.
10. After you have changed the configuration of the remote MultiVOIP, click Download Setup to
update the configuration. The remote MultiVOIP will be brought down, the new configuration
written to the unit, and the unit will reboot.
11. Click Exit after the download completes.
12. The Hangup connection? dialog box displays. Click Yes to disconnect the phone connection
to the remote site.
13. If the same telephone number is not going to be used again in the immediate future, you can
remove it from the Port Setup dialog box.
LAN-Based
The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack. TCP/IP
protocol software must be installed and functional before the configuration program can be used.
1. You must assign an Internet (IP) address for the PC and for each node that will be managed by
the configuration program. Refer to the protocol software documentation for instructions on
how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command for