User guide

Chapter 4 - MultiVOIP Software

Click OK. The MultiVOIP firmware and coders download, then the MultiVOIP reboots.

Manual Upgrade Procedure

Use this procedure only if you want to manually upgrade your MultiVOIP.

Note: Steps 4-8 must be performed via the command port.

1. Run MultiVOIP Configuration from your old version of the MultiVOIP software. Note the current

settings. Your MultiVOIP will be reset to factory defaults during this upgrade.

2. Unistall your old version of MultiVOIP software by selecting the Unistall MultiVOIP Configura-

tion option from the program group.

3. Install the proprietary software from the MultiVOIP CD.

4. From the program group of the MultiVOIP software, select Download Voice Coders. Select

the default file.

5. From the program group of the MultiVOIP software, select Download Factory Defaults.

6. From the program group of the MultiVOIP software, select Download Firmware. Enter *.upg

in the File name box and press ENTER. Select the file named boot.upg.

7. From the program group of the MultiVOIP software, select Download Firmware. Select the file

named mtvoip.bin.

8. Select MultiVOIP Configuration from the program group and reconfigure your MultiVOIP. The

upgrade is complete.