User guide

48
Chapter 4 - MultiVOIP Software
Upgrade Procedures
Whenever you upgrade your version of the MultiVOIP software, you must first install the new software
on your PC. Then, download the Firmware, the Factory Defaults, and the Voice Coders to upgrade the
MultiVOIP.
Before starting the upgrade process, view the current configuration and write down important data such
as your IP address, phone book contents, and voice channel configurations. These settings must be
put back in place after the software has been upgraded.
Two utility programs included in the MultiVOIP software are to be used only after the unit has been
repaired or upgraded. They are Download Firmware and Download Voice Coders.
You can also use the Upgrade Software utility. This is recommended. This utility upgrades the boot
code, factory defaults, firmware, and voice coders in one step. After the files download to the
MultiVOIP, the unit reboots and is ready for use with upgraded firmware and voice coders.
One-Step Upgrade
Click Start | Programs | MultiVOIP 100 v701C | Upgrade Software.
Click Yes. The download process begins.
Enter your LAN IP Address, Subnet Mask, and Gateway Address in the IP Protocol Default Setup
dialog box. Click OK when finished.
Enter your current configuration in the Channel Setup dialog box. Click OK when finished.