User guide

33
Chapter 3 - Software Loading and Configuration
Remote Site Administrator
3. Unpack your MultiVOIP.
4. Connect one end of the power supply to a live AC outlet and connect the other end to the
Power connection on your MultiVOIP.
FXS
Ethernet Connection
Power Connection
ETHERNET
POWER
Voi c e/Fax Channel
Connec t ion
PHONE
Figure 8. Remote Site Cable Connection
5. Connect a network cable to the ETHERNET (RJ-45) connector on the back of your MultiVOIP.
6. If you are connecting a station device such as an analog telephone, a fax machine, or a Key
Telephone System (KTS) to your MultiVOIP, connect one end of an RJ-11 cable to the Phone
connector on the back of the MultiVOIP and the other end to the station device.
7. Turn on power to the MultiVOIP by moving the ON/OFF switch on the right side panel to the ON
position. Wait for the Boot LED on the MultiVOIP to go off before proceeding. This may take a
couple of minutes.
8. At this time your VOIP network should be fully operational. Dial one of the sites in your network
using the dialing directory supplied by your network Administrator.