User guide

32
Chapter 3 - Software Loading and Configuration
19. Click OK and you are returned to the main menu.
20. Click Download Setup to write the new configuration to the client unit. The Save Setup
dialog box displays.
21. Select the Save Current Setup as User Default Configuration check box and click OK.
After the setup is written to the MultiVOIP, the unit reboots.
22. Verify that the Boot LED on the MultiVOIP is Off after the download is complete. This may
take several minutes as the MultiVOIP reboots.
23. You are returned to the main menu.
Your MultiVOIP is operational at this time.
Repeat this procedure for each of the client units. When all clients have been configured, proceed with
deploying the VOIP network.
Deploy the VOIP Network
Deploying the VOIP network involves the VOIP Administrator developing the VOIP Dialing Directory and
deploying the pre-configured client MultiVOIPs to their remote sites. The remote site administrators
need only connect power to the pre-configured MultiVOIP, connect it to their Ethernet LAN and
predefined telephone equipment, and then wait for the phone directory database to be downloaded.
Perform the following procedure to deploy your VOIP network.
VOIP Administrator
1. Establish your VOIP Dialing Directory based on your Phone Directory Database for the numbers
to connect the MultiVOIPs to your VOIP network and the telephone extension number you need
to connect to the Voice/Fax channels. A sample VOIP Dialing Directory is provided below for
your consideration and use.
To call from
Call Process
Dialing
Sequence
VOIP Dialing Directory
2. Send the client MultiVOIPs to their remote sites.