User guide

19
Chapter 3 - Software Loading and Configuration
Installing Your MultiVOIP Software
The following installation procedures do not provide every screen or option in the process of installing
the MultiVOIP software. It is assumed that a technical person with a thorough knowledge of Windows
and the software loading process is doing the installation. Additional information on the MultiVOIP
software is provided in Chapter 4, MultiVOIP Software, and in the online Help.
Configuring Your Host MultiVOIP
Configuring your Host MultiVOIP involves software loading and configuration.
Software Loading
If you are installing a MultiVOIP behind a firewall, add the following UDP ports to your firewall.
900 Signaling Information
5000 Status Information
5004 RTP Packets
5005 RTCP Packets
Refer to your firewall user documentation to enter and open these ports.
1. Verify that your MultiVOIP 100 has been properly cabled, that the power is turned on, and that
the Boot LED is off.
Note: If the Ethernet connection is not active, none of the LEDs will be on after booting. This
unit does not have a Power LED.
2. Insert the MultiVOIP 100 CD into your CD-ROM drive. The CD should start automatically. It
may take 10 to 20 seconds for the MultiTech CD installation window to display.
If the Multi-Tech Installation CD window does not display automatically, click My Computer,
then right click the CD ROM drive icon, click Open, and then click the Autorun icon.
3. When the Multi-Tech Installation CD dialog box displays, click the Install Software icon.