User manual

72
o Never use Single Call Detect disables SCD, and relies entirely on any Voice recognition support
in your modem to avoid leaving empty voice-mail messages. (Use this setting for troubleshooting
call results and in cases where it seems your modem does not seem to be using Single Call
Detect).
4.7.8 Setting single call voice timeout
This timeout determines how long PhoneSweep waits for a modem or fax response after it detects that
something has answered the phone. Sandstorm Enterprises recommends leaving this timeout set at its
default of 5 seconds.
However, if PhoneSweep is leaving blank voice mail messages while dialing in SCD mode, reducing
this value to 4 or 3 seconds may reduce the number of blank voice mail messages left. Too short an
interval may result in PhoneSweep reporting Voice or Timeout when it would otherwise have found a
modem.
Please note that with some combinations of telephone switch and voice mail configuration, it may not be
possible to eliminate all blank voice messages.
After you have customized your dialing preferences, click Save and continue.
After you have set all the options in this section, you are ready to scan! Be sure that the hardware license
management device (the “dongle”) is attached to your computer’s parallel or USB port before you begin
your scan.