User guide

Chapter 2 – Activation and Installation
18 Multi-Tech Systems, Inc. MultiModem rCell User Guide
5. After clicking the Wizard Setup selection, the Wizard Setup screen displays.
77B104BWizard Setup
A minimum router configuration is provided using the Wizard Setup. This provides a quick way to enter and save information
needed to create a connection to the Internet. The table below provides the information for the minimum configuration.
IP Configuration
IP Address The default is 192.168.2.1. To change it, simply enter your own IP address.
Mask The default is 255.255.255.0
DNS Enter the primary DNS IP address for the system. The default is 0.0.0.0
PPP Configuration
PPP
The default is disable. To connect to the Internet, you need to enable PPP.
Depending on the model, commands may need to be issued to the integrated cellular
modem before connecting to the wireless service. To issue commands to the integrated
cellular modem, PPP must be disabled and telnet port 5000 used.
Dial-on-
Demand
The default is disable.
Idle Time Out Sets the amount of time the PPP link stays active before disconnecting. Setting the value
to zero causes the link to stay active continuously.
Dial Number Enter the dial number. This number connects you to the Internet.
For HSDPA, the number is *99***1#.
APN For HSDPA, enter the APN (Access Point Name). The APN is assigned by your wireless
service provider.
Init String You can set up to 4 router initialization strings.
PPP Authentication
Authentication
Type
Click the button corresponding to the authentication protocol you want to use to
negotiate with the remote peer. PAP, CHAP, or PAP-CHAP.
Default = PAP-CHAP
Username Enter the PPP Username. This name authenticates the remote peer.
Password Enter the PPP Password. This password authenticates the remote peer.