User`s guide

Chapter 1 – AT Commands for Remote SIM Application Toolkit

Multi-Tech Systems, Inc. SIM Application Toolkit AT Commands (S000391C) 40

1.5.3.5 AT^SSTR Remote-SAT Event Response – Browser Termination (236)

Write Command

AT^SSTR=236, ,

Sent by the customer application to indicate that the Internet browser application has

been terminated.

Response

Parameters

<cmdType> 236 – Proactive command ID. See Table 1.

<Term Cause> Unsigned Integer, range 0-255.

Browser Termination Cause.

0 User termination.

1 Error termination.

1.5.3.6 AT^SSTR Remote-SAT Event Response – Terminate Command (254)

Write Command

AT^SSTR=254

This command allows the TA to finish an ongoing proactive command. This is done

by sending repeatedly a terminal response, “ME currently unable to process

command - screen is busy,” to the SIM (see Table 1”) if issued in states PAC or

WAIT. No action is performed if the interface is already in IDLE state. However, the

command returns “OK”.

The reaction to the terminal response depends on the SIM application.

The command can be used to return to IDLE state whether or not a proactive

command is ongoing.

Response

Note

This command is allowed in states IDLE, PAC and WAIT and forces a return to the

IDLE state once it has been issued successfully; i.e., OK response.