User`s guide

Chapter 1 – AT Commands for Remote SIM Application Toolkit
Multi-Tech Systems, Inc. SIM Application Toolkit AT Commands (S000391C) 38
1.5.2.14 AT^SSTR Remote-SAT Response – Set Up Menu (37)
Write Command
AT^SSTR=37,
<status>
Note
As with every proactive command the TA is expected to acknowledge the ^SSTGI
response with AT^SSTR to confirm that the proactive command has been executed.
The response simply conveys, to the SAT, the information that the main menu was
received and set up on the user interface. It does not transmit any information about
a selected item as in the case of AT^SSTR=36.
Once this command was executed the user can proceed as described in section
1.5.3.1.
Response
OK
Parameters
<cmdType> 37 – Proactive command ID. See Table 1.
<status> Unsigned Integer, range 0-255.
0 Command performed successfully (proactive session will end).
32 TA currently unable to process command.
132 TA currently unable to process command because screen is busy.
1.5.2.15 AT^SSTR Remote-SAT Response – Set Up Idle Mode Text (40)
Write Command
AT^SSTR=40,
<status>
The TA indicates whether the set up Idle mode text command was correctly
executed.
Response
OK
Parameters
<cmdType> 40 – Proactive command ID. See Table 1.
<status> Unsigned Integer, range 0-255.
0 Command performed successfully.
32 TA currently unable to process command.
132 TA currently unable to process command because screen is busy.