User`s guide

Chapter 1 – AT Commands for Remote SIM Application Toolkit
Multi-Tech Systems, Inc. SIM Application Toolkit AT Commands (S000391C) 33
1.5.1 Remote-SAT Command Status
The following status values give a response to a previously issued Proactive command and are used by the
AT Command AT^SSTR. The status parameter is used to identify the type of response from the TA to the ME.
This table is based upon GSM 11.14.
Status
Value
Terminal
Response
Refresh
1
Setup
Event
List
5
Set Up
Call
16
Send
SS
17
Send
USSD
18
Send
SMS
19
Send
DTMF
20
Launch
Browser
21
Play
Tone
32
Display
Text
33
Get
Inkey
34
Get
Input
35
Select
Item
36
Set Up
Menu
37
Setup
Idle
Mode
Text
40
00 Command
performed
successfully
X X X X X X X X X X X X X X X
16 Proactive SIM
session terminated
by user
X X X X X X X
17 Backward move in
the proactive SIM
session requested
by the user
X X X X
18 No response from
user
X X X X
19 Help information
required by the user
X X X
20 USSD/SS Transact
terminated by user
X X X
32 ME currently unable
to process
command
X X X X X X X X X X X X X X X
132 ME currently unable
to process
command -
screen is busy
X X X X X X X X X X X X X X X
34 User did not accept
the proactive
command
X X
35 User cleared down
call before
connection or
network release
X
1.5.2 Proactive Commands
1.5.2.1 AT^SSTR Remote-SAT Response – Refresh (1)
Write Command
AT^SSTR=1,
<status>
If <cmdDetail> reported by AT^SSTGI was 4, the ME is performing a SIM reset.
Therefore, a terminal response should not be issued.
Response
OK
Parameters
<cmdType> 1 – Proactive command ID. See Table 1.
<status> Unsigned Integer, range 0-255.
0 Command performed successfully.
32 TA currently unable to process command.
132 TA currently unable to process command because screen is busy.
1.5.2.2 AT^SSTR Remote-SAT Response – Set Up Event List (5)
Write Command
AT^SSTR=5,
<status>
The TA is acknowledging that the event list has been set up correctly.
Response
OK
Parameters
<cmdType> 5 – Proactive command ID. See Table 1.
<status> Unsigned Integer, range 0-255.
0 Command performed successfully.
32 TA currently unable to process command.
132 TA currently unable to process command because screen is busy.