User guide

Chapter 3 – General Commands
Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide (PN S000478C) 13
Enable/Disable Individual Unsolicited Message Mask
Bits +WUSLMSK
Description: The intent of this AT command is to enable/disable individual unsolicited message mask bits to
be sent out to the serial port. This is a 64-bit mask that determines which messages are enabled
or disabled. The setting is persistent over power cycle. The default setting is to allow all
unsolicited messages.
Syntax: Command Syntax: AT+WUSLMSK=<mask-bit>, <mask>
Command Possible Responses
AT+WUSLMSK?<cr>
Note: Ask for current setting
+WUSLMSK: FFFFFFFEFFFFFFDE
OK
AT+WUSLMSK=?<cr>
Note: Ask for possible values
+WUSLMSK: (00000000-FFFFFFFF),(0-1)
OK
AT+WUSLMSK=FFFFFFFF,0<cr>
Note: Enable All Unsolicited Messages
Associated with the lower 32 bit mask
OK
AT+WUSLMSK=00020000,0<cr>
Note: Enable ONLY +WIND Unsolicited
Messages in the lower 32bit mask
OK
AT+WUSLMSK<cr>
Note: Enable All Unsolicited Messages
OK
Values: The parameters values are:
<mask-bit> Currently only 32 bits are used for masking of unsolicited responses.
00000000 All mask bits off.
{various combinations in between (e.g., 0F817DFE).}
FFFFFFFF All mask bits on.
<mask>
0 Write bit mask values to the lower 32 bit mask.
1 Write bit mask values to the upper 32 bit mask.
The <mask-bit> bits correspond to the unsolicited response table below.
Lower 32-Bit Mask Note: Upper 32-bit Mask is not used at this time.
Bit Mask Value Unsolicited
Response
Response for:
0 0x00000001 "+WSRV:" Service State change
1 0x00000002 "+CCWA:" Call waiting notification
2 0x00000004 "+CSQ:" RSSI change across threshold
3 0x00000008 "+CLIP:" CPN or CNAP notification
4 0x00000010 "+WORG:" Call State origination
5 0x00000020 "+CRING:" Call State incoming
6 0x00000040 "+WANS:" Call State answered
7 0x00000080 "+WCNT:" Call State conversation
8 0x00000100 "+WEND:" Call End status
9 0x00000200 "+COPS:" System mode, band, roam settings
11 0x00000800 "+WPRV:" Privacy change
12 0x00001000 "+WROM:" Roaming change
13 0x00002000 "+CREG:” Registration information
15 0x00008000 "+WSPS:" Enter/Exit Power Save Mode (no service found)
16 0x00010000 "+WNAM:" Current NAM change
17 0x00020000 "+WIND:" generic unsolicited message WIND
18 0x00040000 "+WOTA:" OTASP or OTAPA programming info
19 0x00080000 "+WUZ:" User zone notification
20 0x00100000 "+WTS:" Diagnostic Timestamp
21 0x00200000 "DTMF:" Uplink DTMF sent
22 0x00400000 "PINGRING" Ping Ring