User guide

21
Configuration
If you are connecting to a Telco, get the following T1 information from
your Telco :
Line Code: AMI/B8ZS__________________________________
Framing Format: D4/ESF________________________________
Available bandwidth: Full T1 (24 DS0s), or
Number of DS0s and which DS0 assignments, if FT1. _________
If you are using your MultiDSU as a short-haul modem, select the
identical line coding and framing format to be used in both units.
Power up a terminal or PC running communications software. When the
T1 DSU Main Menu appears on your screen, perform the procedures in
the rest of this section, then run each of the loopback tests to check all
the lines and interfaces.
1. Apply power to your terminal or PC. After the terminal or pc boots
up, run communications software. Set up your communications
software for 19.2K bps, 8N1 (8-bits, no parity, and 1-stop bit).
Press the ENTER key to display the MultiDSU Main Menu.
T1 DSU Main Menu
1. Configurations
2. Current Status
3. Statistics
4. Diagnostics
5. System Information
Enter Selection (-(previous), q(uit), <1>): _
2. Enter option 1 and press the ENTER key to display the Configura-
tions menu.
Configurations
1. T1 Line Configuration
2. DS0 Speed/DS0 Allocation
3. Clocking
4. V.35 Port
5. Set configurations
6. Set and Save configurations
7. Reset to Factory Defaults
Enter Selection (-(previous), q(uit), <1>): _