User guide
Table Of Contents
- Product Overview
- Safety Warnings
- Cellular Information
- Installing and Using the Router
- Regulatory Information
- Industry Canada and FCC
- FCC and IC Antenna Requirements Toward License Exempt Radio Transmitters (Bluetooth/Wlan)
- Requirements for Cellular Antennas with regard to FCC/IC Compliance
- EMC, Safety, and R&TTE Directive Compliance
- Restriction of the Use of Hazardous Substances (RoHS)
- REACH Statement
- Waste Electrical and Electronic Equipment Statement
- Information on HS/TS Substances According to Chinese Standards
- Information on HS/TS Substances According to Chinese Standards (in Chinese)
PRODUCT OVERVIEW
Ethernet LED Descriptions
Two Ethernet LEDs are physically on the RJ-45 connector(s). The table that follows describes these LEDs.
Ethernet Link Right LED on Ethernet connector. Blinks when there is transmit and
receive activity on the Ethernet link. It shows a steady light when
there is a valid Ethernet connection.
Ethernet Speed Left LED on Ethernet connector. Lit when the Ethernet is linked at 100
Mbps. If it is not lit, the Ethernet is linked at 10 Mbps.
Specifications
MTR-H5
Category Description
General
Performance HSPA+
GPRS/EDGE
Frequency Bands Tri-Band 850/900/2100 MHz
Quad Band 850/900/1800/1900 MHz
Radio
Cellular Telit HE910-D
Wi-Fi, Bluetooth Murata LBEE5ZSTNC-523
Speed
Packet Data Up to 7.2 Mbps downlink/5.76 Mbps uplink
SMS
SMS Point-to-Point Messaging
Mobile-Terminated SMS
Mobile-Originated SMS
Connectors
Cellular Female SMA connectors for cellular
WiFi Reverse polarity male SMA connector for Wi-Fi
MultiConnect
®
rCell 100 Series Router User Guide 9