User guide

ProxyServer User Guide
MTPSR3-200106
Command: &Mn Communications Mode
Values: n = 0
Defaults: 0
Description: &M0 Asynchronous mode.
&M1 Reserved—responds ERROR.
Command: &Qn Asynchronous Communications Mode
Values: n = 0, 5, or 6
Defaults: 5
Description: &Q0 Asynchronous with data buffering. Same as \N0.
&Q5 Error control with data buffering. Same as \N3.
&Q6 Asynchronous with data buffering. Same as \N0.
Command: &Sn Data Set Ready (DSR) Control
Values: n = 0 or 1
Default: 0
Description: &S0 Force DSR high (on).
&S1 Let DSR follow CD.
Command: &Tn Self-Test Commands
Values: n = 0, 1, 3 or 6
Default: None
Description: &T0 Abort. Stop any test in progress.
&T1 Local analog loop test.
&T3 Local digital loopback test.
&T6 Remote digital loopback test.
Command: &V View Current Configuration
Values: n/a
Description: Displays the active modem settings.
Command: &Wn Store Current Configuration
Values: n = 0
Default: None
Description: &W0 Store active modem settings in NVRAM; load them at power-on or following the ATZ command
instead of loading the factory defaults from ROM.
Command: &Yn Select Stored Configuration for Hard Reset
Values: n = 0
Default: 0
Description: &Y0 Select stored configuration 0 on power-up. (For backward compatibility with some software.)
&Y1 Not supported—responds ERROR.
Command: &Zn=x Store Telephone Number
Values: n = 0, 1, 2, or 3
x = Dialing string
Default: None
Description: Stores telephone dial string x in memory location n. Dial the stored number using the command
ATDS=n.
Command: \Gn Modem Port Flow Control
Values: n = 0
Default: 0
Description: \G0 Returns an OK for backward compatibility with some software.
\G1 Not supported—responds ERROR.
Command: \Jn Data Buffer Control
Values: n = 0
Default: 0
Description: \J0 Enable data buffer—serial port speed is independent of connect speed.
\J1 Not supported—responds ERROR.