User guide

DSU ProxyServer Quick Start Guide
8
4 Place the unit on a flat, grounded surface, with the LED’s
facing you.
5 Pry the shunt out of the RS232 position, and insert it in the
V.35 position.
5
6
7
8
V.35 Shunt Position
RS232C Shunt Position
Back Panel Connectors
8-Position DIP Switch
RAM Sockets
LEDs
Figure 2-3. Shunt Positions
6 Align the board with the guide slots on the inside of the
chassis and carefully slide the board back into the chassis.
7 Being sure to support the back panel, turn the
ProxyServer over again, and replace the cabinet mounting
screw.
8 Turn the ProxyServer right-side-up again and proceed to
the nect section to connect the cables.