User guide

82 MTPSR2-201
DSU ProxyServer User Guide
Introduction
This chapter provides procedures for viewing or changing the configuration of a remote unit.
Remote configuration requires the ProxyServer software to be loaded on the local PC. The local PC
then controls the remote ProxyServer via the LAN.
Remote Configuration
Remote configuration is LAN-based and requires a Windows Sockets compliant TCP/IP stack. TCP/
IP protocol software that must be installed and functional before the configuration program can be
used.
1. You must assign an Internet (IP) address for the PC and for each node that will be
managed by the configuration program. Refer to the protocol software documentation for
instructions on how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping
command for the PC host name. You should also test the network interface configuration
by Pinging another TCP/IP device that is connected to the network.
2. Install the ProxyServer software on the local PC. Once installed click Start | Programs |
ProxyServer 2.10 | Configuration Port Setup.
3. The ProxyServer Port Setup dialog box is displayed.
Verify that the Communication Type field is set to IP.
In the ProxyServer IP Address field, enter the IP Address of the remote ProxyServer.
Click OK when you are satisfied with your selections.
4. The windows Program Manager menu is displayed.
Double-click the ProxyServer Configuration icon.
5. The Reading Configuration. Please wait ... screen is displayed.