User guide

Chapter 5 - Client Setup

MTPSR2-201

Configuring in Windows NT

Perform the following steps to set up your Windows NT workstation PC:

Note: All of the hardware and screen samples in this section are intended as examples only. Please

select options appropriate to your network.

1 Click Start | Settings | Control Panel and then double-click the Network icon.

The Network dialog appears.

2 Click the Protocols tab.

3 A list of protocols currently present on your PC is displayed. Check the installed protocols. If

you find TCP/IP Protocol listed, proceed to step 4. If TCP/IP is not listed, you must install it

prior to proceeding. Refer to Installing TCP/IP (WinNT), at the end of this section.

4 Click the Bindings tab.