User guide

33
Chapter 4 - ProxyServer Software
MTPSR2-201
Port refers to the type of port - LAN, in our current example. If you have a modem connected to WAN
2 and are using WAN 2 for RAS, you can set up a static route to send incoming traffic over to a
different network. The IP Address must be the address (in dotted decimal form) of the target host or
network in the static route. (In our example, Static Route IP Address 200.1.1.0 indicates that PC
clients on routers with IP addresses beginning with “200.1.1” will be included on the static route.) The
Address Mask is the IP subnetwork mask (255.255.255.0) of the target host. The Gateway Address
must be the IP address (in dotted decimal form) of the local router (Gateway Address 192.168.2.1) on
the next hop toward the target host and the port (i.e., LAN) with which it is associated. Metric is the
hop count (1) to the target host; this value can be either 0 or 1.
Once you have entered all the necessary information, click OK. The static route is added to the Static
Routes table.