User guide

14
DSU ProxyServer User Guide
MTPSR2-201
4 Place the unit on a flat, grounded surface with the LED’s facing you.
5 Pry the shunt out of the RS232 position, and insert it in the V.35 position.
5
6
7
8
V.35 Shunt Position
RS232C Shunt Position
Back Panel Connectors
8-Position DIP Switch
RAM Sockets
LEDs
Figure 2-4. Shunt Positions
Note: if you wish to make changes to the 8-position DIP switch, do so at this time. For
details on DIP switch settings, refer to the previous section, 8-Position DIP Swtich.
6 Align the board with the guide slots on the inside of the chassis and carefully slide the
board back into the chassis.
7 Being sure to support the back panel, turn the ProxyServer over again, and replace the
cabinet mounting screw.
8 Turn the ProxyServer right-side-up again and proceed to the nect section to connect the
cables.