User guide
Table Of Contents
- Product Overview
- Hardware and Installation
- Installing Drivers
- Regulatory Information
- Labeling Requirements
- Environmental Notices
- Index
HARDWARE AND INSTALLATION
Dimensions with brackets attached for rack mounting (top view)
Dimensions with brackets attached for rack mounting (front view)
Note:
Attaching the device to the rail of an EIA 19-inch rack enclosure may require two people.
1. Position a mounting bracket on the right side as shown.
2. Secure the bracket to right side using three provided screws as shown.
3. Position a mounting bracket on the left side.
4. Secure the bracket to left side using three provided screws.
5. Remove feet (4) from the unit.
6. Secure the unit to rack rails by the brackets and mount the MTMC 8/16 in the rack enclosure per the rack
manufacturer's mounting procedure. Because equipment racks vary, screws for rack-rail mounting are not
provided. Follow the instructions of the rack manufacturer and use screws that fit.
Cabling your Device to a Computer
To cable the device:
1. Connect the power cord to an outlet or power strip and to the power adapter.
2. Connect the power adapter to the 9V connector on the MTMC.
12 MultiModem
®
USB MTMC8-USB/MTMC16-USB User Guide