User guide

Chapter 2 – Modem-Specific Commands
High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 29
!SCPADDR Return IP Address for Specified PDP Context
Syntax: Execution: AT!SCPADDR=[<pid>]
Response: !SCPADDR: <pid><addr>
[!SCPADDR: <pid>, <addr>
[...] ]
OK
Purpose: Return the IP address for the specified <pid>. If <pid> is blank, return IP
addresses for all defined profiles.
Description: Return the IP address of the specified PDP context (profile), or for all profiles.
Parameters: <pid> (Profile ID (PDP context)):
Valid range: 1–16
<addr> (IP address of <pid>):
‘Dot’ format IP address (for example, 255.255.255.0)
!SCPROF Set/Return SWI-Specific Profile Information
Syntax: Execution: !SCPROF=<pid>, Label>, <autoconnect>, <promptforpassword>,
<autolaunchapp>, <rffu>
Response: OK
Purpose: Set the SWI-specific information for the specified profile (<pid>).
Query: !SCPROF?<pid>
Response: !SCPROF: <pid>, <label< <autoconnect>, <promptforpassword>,
<autolaunchapp>, <rffu>
Purpose: Report current SWI-specific information for the specified profile (<pid>).
Description: Set or return the SWI specific information for a profile.
Parameters: <pid> (PDP context definition):
Valid range: 1–16 — a valid profile ID that will be used as the default
<label> (Configuration buffer label):
30-character string surrounded by quotation marks
<autoconnect> (Automatic context activation mode):
0 = manual activation
1 = auto activation
<promptforpassword> (Flag value (prompt for password)):
0 = do not prompt for password
1 = prompt for password
<autolaunchapp> (Flag value (auto launch application)):
0 = do not auto launch the application
1 = auto launch the application
<rffu> (Reserved for future use):
0–32767 = Reserved