User guide

Chapter 4 – Device Configuration
26 Multi-Tech Systems, Inc. MultiConnect AW User Guide
MultiConnect AW Security
Option Default Selection
O) PhyTimeout (Min) 15 Min
Physical Timeout is how long the MultiConnect wait before
dropping a connection if no activity is sensed on the
network.
Enter a value between 0 and 255 minutes. Zero (0) disables
the timeout. The default is 15 minutes.
Normally, this option should be left in the default value.
P) DLE Mode 1
If set to 0, no specific process is needed on [ETX]
characters. This means that a host cannot request an end
of connection or receive a clear indication of the end of a
connection from the TCP/IP stack.
If set to 1, the [ETX] characters means a request or an
indication of end of connection. As a result, [ETX]
characters that belong to the payload must be sent by the
host on the serial port preceded by a DLE character.
Similarly, EXT characters received by the TCP/IP stack from
the Internet are sent to the host through the serial port
preceded by a DLE character.
Q) TCP TxDelay
100
milliseconds
This setting determines the time delay before sending a
TCP frame that is not entirely filled with user data.
Enter a time in milliseconds. A value of 0 sends a TCP frame
as soon as possible after the receiving a single character
value from the host.
R) Handshake TimeOut (sec) 90 seconds
This is a wireless modem timeout of between 1 and 255
seconds. Default is 90 seconds.
S) SIM Pin Code Not required
With the default setting, 1, a SIM pin code is not required.
Select 2 to enter or change a pin code. The pin code is a
four to eight digit number.
Note: After 3 unsuccessful attempts to enter the PIN, the
PUK (Personal Unblocking Key) will be required.
Z) Enter Wireless Modem
Command Mode
Select this to open the command port on the wireless
modem to enter AT commands.