User guide

Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem rCell User Guide 29
Example 3 – Set Up the Ethernet Router to Activate on Matching Caller IDs Only:
1. On the PPP > PPP Configuration screen, set up the following parameters:
PPP General
● Make sure that PPP is Enabled.
● Make sure Dial-on-Demand is Enabled.
● Set the Idle Time Out to the number of seconds you desire.
Authentication
● Your wireless service provider may require you to have a separate PPP username and password. If so,
enter them here.
Note: If a username and password are required, your wireless provider would have given them to you
when you activated your account.
Modem Configuration
● Make sure your Dial Number is entered correctly:
For HSPA models, the Dial Number is *99***1#
For EV-DO models, the Dial Number is #777
Submit
● Click the Submit button to save the changes made on this screen.
2. On the PPP > Wakeup-on-Call screen, set up the following parameters:
Wakeup-on-Call Configuration
● Select Enable for Wakeup-on-Call.
● Set the Time Delay. You can use the 10 second default.
● Enter the Init Strings:
Set Wakeup Init String 1 by entering AT+CLIP=1 for HSPA models only.
● Submit Button
Click the Submit button to save these settings.
Caller ID Configuration
● Enter a caller‟s ID that you want added to the Caller ID list.
● Add Button
Click the Add button to save each Caller ID as it is entered to the Caller ID list.
3. Save and Restart
Click Save and Restart once you have completed and submitted all the screens on which you have made
changes. The device will save all the settings and reboot the PC.
The Power-On Configuration feature allows you to set an initialization string that will be sent to the router upon boot up.
Power-On Init String Configuration
Power-On Init String: You can enter a string of 0 to 40 characters that will be sent to the router upon boot up. All
commands will initialize before you proceed with regular PPP related activity.
Note: When no initialization string is configured, regular functionality of the router is retained.
Submit: Click the SUBMIT button to save this setting.
Note: You must click Save and Restart once you have completed and submitted all the
screens on which you have made changes.