User guide

Chapter 3 – Using the Web Management Software
28 Multi-Tech Systems, Inc. MultiModem rCell User Guide
Caller Acknowledgement Configuration
Acknowledgement String to Caller: The configured string of (0 to 40 characters) will be sent to the integrated cellular
modem upon receiving a valid caller ID from the WAN. The default is NULL string.
Note: If the string is not configured, acknowledgement to the caller will not be sent upon successful
caller ID reception.
Submit
Click the SUBMIT button to save these settings.
Note: You must click Save and Restart once you have completed and submitted all the screens on which you have made
changes.
PPP > Wakeup-On-Call Examples
Example 1 – Determine if the router Is Supporting Incoming Calls and Caller ID
1. On the PPP > PPP Configuration screen, make sure that PPP is Disabled.
2. On the PPP > Wakeup-on-Call screen, make sure that Wakeup-on-Call is Disabled.
3. Open a command prompt by clicking the Start button and selecting Run.
4. Type CMD to open the command window. Click OK.
5. When the command window opens, telnet to the router.
Note: 5000 is the router port number.
5.1. Enter your username and password to login.
5.2. Enter an AT command to make sure you receive a response; i.e., OK.
5.3. On HSPA modlels, enter the Command AT+CNUM to determine the dial number of your router.
6. From another phone, call your router using the number identified in Step 5.3. This will let you know if the RING
message shows.
7. To enable Caller ID, enter the AT+CLIP=1 command on the command screen and make the call again to see if it
shows Caller ID information.
Notes:
● Step 5.3 must show the RING or CALLER ID information in order for the Wakeup-on-Call function to work.
● Some wireless providers might not provide caller ID information if you have only a data plan.
Example 2 – Set Up the Ethernet Router to Activate on ALL Incoming Calls
1. On the PPP >PPP Configuration screen, set up the following parameters:
PPP General
● Make sure that PPP is Enabled.
● Make sure Dial-on-Demand is Enabled.
● Set the Idle Time Out to the number of seconds you desire.
Authentication
● Your wireless service provider may require you to have a separate PPP Use name and Password. If so,
enter them here.
Note: If a username and password are required, your wireless provider would have given them to you when
you activated your account.
Modem Configuration
● Make sure your Dial Number is entered correctly:
For HSPA models, the Dial Number is *99***1#
For EV-DO models, the Dial Number is #777
Submit
● Click the Submit button to save the changes made on this screen.
2. On the PPP > Wakeup-on-Call screen, set up the following parameters:
Wakeup-on-Call Configuration
● Select Enable for Wakeup-on-Call.
● Set the Time Delay to 3 seconds. You can use the 10 second default.
● All Init Strings should be empty.
● Submit Button
Click the Submit button to save these settings.
Caller ID Configuration
● Enter the string RING to the Caller ID list.
● Click the Add Button to save the string to the Caller ID list.
3. Save and Restart
Click Save and Restart once you have completed and submitted all the screens on which you have made
changes. The device will save all the settings and reboot the PC.