User guide

Chapter 2 – Installation
Multi-Tech Systems, Inc. MultiModem rCell User Guide 15
5. After clicking the Wizard Setup selection, the Wizard Setup screen displays.
A minimum router configuration is provided using the Wizard Setup. This provides a quick way to enter and save information
needed to create a connection to the Internet. The table below provides the information for the minimum configuration.
IP Configuration
IP Address
The default is 192.168.2.1. To change it, simply enter your own IP address.
Mask
The default is 255.255.255.0
DNS
Enter the primary DNS IP address for the system. The default is 0.0.0.0
PPP Configuration
PPP
The default is disable. To connect to the Internet, you need to enable PPP.
Depending on the model, commands may need to be issued to the integrated cellular
modem before connecting to the wireless service. To issue commands to the integrated
cellular modem, PPP must be disabled and telnet port 5000 used.
Dial-on-
Demand
The default is disable.
Idle Time Out
Sets the amount of time the PPP link stays active before disconnecting. Setting the value
to zero causes the link to stay active continuously.
Dial Number
Enter the dial number. This number connects you to the Internet.
For HSPA, the number is *99***1#.
For EV-DO models, the Dial Number is #777.
APN
For HSPA models, enter the APN (Access Point Name). The APN is assigned by your
wireless service provider.
For EV-DO models, the APN does not apply
Init String
You can set up to 4 router initialization strings.
PPP Authentication
Authentication
Type
Click the button corresponding to the authentication protocol you want to use to
negotiate with the remote peer. PAP, CHAP, or PAP-CHAP.
Default = PAP-CHAP
Username
Enter the PPP Username. This name authenticates the remote peer.
Password
Enter the PPP Password. This password authenticates the remote peer.