User guide

Multi-Tech Systems, Inc. MultiModem rCell User Guide 10
The router requires the power supply connection to begin operation. It also requires a SIM card (Subscriber Identity Module) to
operate on a GSM network. To install the SIM, do the following:
1. Open the SIM door by pressing down on the tab on the top of the door and prying it open.
Note: When changing a SIM, ensure that power is removed from the unit.
2. Insert the SIM card into the card holder. The above graphic illustrates the correct SIM card orientation.
3. Verify that the SIM card fits into the holder properly and then close the cover.
1. Connect a suitable antenna to the SMA connector (see antenna specifications in Chapter 1).
2. Using an Ethernet cable, connect one end of the cable to the ETHERNET connector on the back of the router and the
other end to your pc either directly or via a switch or hub.
3. Attach the appropriate interchangeable blade piece to the power supply module.
4. Screw-on the power lead from the power supply module into the power connection on the router. Now, plug the power
supply into your power source.
Notes
● The POWER LED. The POWER LED lights after power-up.
● The Status LED is a solid ON when the router is booting up, saving a configuration, or updating firmware. When
the Status LED begins to blink, the router is ready.
The Reset Button. Hold the Reset button in until the Status Light goes out. Then release it. It also will set the
username and password back to admin and admin as well as setting the IP address to the default of 192.168.2.1.