User guide

Chapter 3 – Using the Web Management Software
39 Multi-Tech Systems, Inc. MultiModem rCell User Guide
AT+CREG? Network Registration
Notes: You can also retrieve the integrated cellular modem information without using a browser:
 Make a TCP connection to port 80 (same as the Web Admin port) and send data as:
GET /atinfor.html HTTP/1.1
 Then press Enter twice.
Refer to the AT Command Reference Guide for other commands.
Networks & Services
Networks & Services > Network Configuration
Networks or Hosts can be added here. The options to Delete or Edit a network after it has been defined and
added are available by using the table at the bottom of the screen.
Network Configuration
Enter the Name, IP Address, and Mask for a new Network or Host.
Notes:
A Network/Host Name:
● Cannot be edited.
● Cannot be deleted if it is used in another configuration.
● Changes are reflected in all the configurations in the Web Management software where they are used.
● If added here will display in the following sections: Static Routes, DNAT, and Packet Filters.
Name: Enter the name of the Network/Host. The same address-mask pair should not already
be present in the displayed list. The Name is limited to 15 characters maximum.
IP Address: Enter the IP Address of the Network/Host. The same address-mask pair should not
already be present in the displayed list.
Subnet Mask: Enter the Network Mask of the Network/Host. For Host addresses, the mask is entered
as 32. For more information, see Appendix A -- Table of Commonly Supported Subnets.