Specifications

Chapter 10 – V24-V25 Commands
Multi-Tech Systems, Inc. CDMA AT Commands Reference Guide (PN S000294K) 62
Request Identification Information I
Description: This command causes the product to transmit one or more lines of information from the DCE.
Values: <num>
0 Manufacturer data
1 Not used
2 Not used
3 Software revision data
4 Not used
5 Configuration data
6 Capability data
7 Not used
Note: For the data returned by the ATI6 command, the use of the IS-707 +GCAP command is preferred.
Syntax: Command syntax: ATI<num>
Command Possible Responses
ATI0
Note: Display manufacturer data
MODEM
800 1900
OK
ATI3
Note: Display software revision data
S/W VER: WISMOQ …
OK
ATI6
Note: Display capability data
+CGSM, +CIS707, …
OK
Restore Factory Setting &F
Description: This command is used to restore the factory setting from NV memory. See Chapter 19. This command will
reset the modem as the very last part of its operation.
Note: There is a remote chance of NVRAM corruption of a modem reset or power loss occurs during the
processing of this command. This command should be used only during initial setup of the modem’s
operating characteristics.
Syntax: Command syntax: AT&F
Command Possible Responses
AT&F OK
Note: Command valid, modem resets
Save Configuration &W
Description: This command writes the current configuration to NV. See table in Chapter 19 for a list of items.
Syntax: Command syntax: AT&W
Command Possible Responses
AT&W OK
Note: Command valid