Specifications

Chapter 2 – Configuration Commands
Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 37
<AutoExecState> AutoExec Command Status
This parameter is part of the Autoexec URC which is presented when a
scheduled Autoexec activity is being performed.
1 The value 1 indicates that the Autoexec activity specified with <AutoExec-
ATC> is currently executed.
<ecc> Emergency call numbers on non-ECC SIM
This parameter specifies emergency call numbers on SIM cards without ECC
field. The parameter has no influence on the commonly used emergency
numbers 112 and 911 which are always supported.
Please refer also to Section 7.3, ATD where you can find a list of emergency
call numbers supported if no SIM is inserted.
The value range of <ecc> is 0...255. To select or deselect an emergency
number calculate the sum of the values of all desired numbers and use the
resulting value. For example, for 08 (2) and 118 (8) please enter the value (10).
Parameter is global for the ME, non-volatile and will not be reset by AT&F.
0 No additional emergency numbers
1 000
2 08
4 110
8 118
16 119
32 999
64 Reserved
128 Reserved
255 All additional emergency call numbers are supported. Default.
<gs0aa> 0 with Attach
This parameter can be used to control the behavior of ATS0.
Parameter is global for all interfaces, volatile, and will not be reset by AT&F.
on When the ATS0=<n> (<n>>0) command is received, the MT will attempt
to perform a GPRS attach. Default – This is the powerup default value
which is not stored at power down
off When the ATS0=<n> (<n>>0) command is received, the MT will not
attempt to perform a GPRS attach.
<gs0aa> GPRS ATS0 with Attach
This parameter can be used to control the behavior of ATS0.
Parameter is global for all interfaces, volatile and will not be reset by AT&F.
on When ATS0=<n> (<n>>0) is received, the MT will attempt to perform a
GPRS attach. This is the power up default value of this parameter.
off When ATS0=<n> (<n>>0) is received, the MT will not attempt to
perform a GPRS attach.
<gaa> GPRS with Auto Attach
This parameter can be used to control whether the ME will perform a GPRS
attach immediately after registering to the network or not. If the setting is
changed to “enabled” and the ME is not attached yet, it will not initiate an attach
immediately but after the next registration to the network.
The parameter is global for all interfaces, non volatile, and will not be reset by
AT&F.
disabled GPRS auto attach is disabled. Default.
enabled GPRS auto attach is enabled.
<gpc> GPRS with Persistent Contexts
This parameter can be used to control whether the ME will store the GPRS
context information defined by the AT+CGDCONT volatile or non volatile.
Parameter is global for all interfaces, non volatile, and will not be reset by AT&F.
0 GPRS context definitions are volatile. Default.
1 GPRS context definitions are non-volatile and will not be reset by AT&F.