Specifications

Chapter 2 – Configuration Commands
Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 21
2.4 ATQ Set Result Code Presentation Mode
Description: This command determines whether or not the TA (terminal adapter) transmits any result code to
the TE (terminal equipment). Other Information text transmitted in response is not affected.
Syntax: Exec Command: ATQ[<n>]
Response: If <n> = 0:
OK
If <n> = 1:
(none)
Parameters: <n>
0 DCE (Data Communication Equipment) transmits result code. Factory default;
it can be restored to 0 with AT&F.
1 Result codes are suppressed and not transmitted
Notes:
• This command is not PIN protected.
• This command is supported in airplane mode.
• Store the parameters with the AT&W command.
• Display the parameters with the AT&V command.
2.5 ATV Set Result Code Format Mode
Description: This command determines the contents of the header and trailer transmitted with AT command
result codes and information responses. Possible responses are described in Section 2.5.1,
Verbose and Numeric Result Codes.
Syntax: Exec Command: ATV[<value>]
Response: OK
ERROR
Parameter:
<value>
0 Information response: <text><CR><LF> Default value if the parameter is omitted (0 is
then assumed)
Short result code format: <numeric code><CR>
1 Information response: <CR><LF><text><CR><LF> (Factory default value. It can be
restored to 1 with AT&F)
Long result code format: <CR><LF><verbose code><CR>.
Notes:
• This command is not PIN protected.
• This command is supported in airplane mode.
• Store the parameters with the AT&W command.
• Display the parameters with the AT&V command.
2.5.1 Verbose and Numeric Result Codes
Verbose format Numeric format Meaning
OK 0 Command executed, no errors
CONNECT 1 Link established
RING 2 Ring detected
NO CARRIER 3 Link not established or disconnected
ERROR 4 Invalid command or command line too long
NO DIALTONE 6 No dial tone, dialing impossible, wrong mode
BUSY 7 Remote station busy
CONNECT 2400/RLP 47 Link with 2400 bps and Radio Link Protocol
CONNECT 4800/RLP 48 Link with 4800 bps and Radio Link Protocol
CONNECT 9600/RLP 49 Link with 9600 bps and Radio Link Protocol
CONNECT 14400/RLP 50 Link with 14400 bps and Radio Link Protocol
ALERTING Alerting at called phone
DIALING Mobile phone is dialing