Specifications

Chapter 2 – Configuration Commands
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 31
Write Command for Radio Band Selection: AT^SCFG=”Radio/Band”[, <rbp>][, <rba>]
Write Response(s):
^SCFG: “Radio/Band”, <rbp>, <rba>
OK
ERROR
+CME ERROR
Write Command for Configuration of URC “+CIEV: call” Call Status Indication:
AT^SCFG=”URC/CallStatus/CIEV”[, <succ>]
Write Responses:
^SCFG: “URC/CallStatus/CIEV”, <succ>
OK
ERROR
+CME ERROR
Write Command for Configuration of URC “^SLCC” Call Status Indication:
AT^SCFG=”URC/CallStatus/SLCC”[, <sucs>]
Write Responses:
^SCFG: “URC/CallStatus/SLCC”, <sucs>
OK
ERROR
+CME ERROR
Write Command for URC Indication in Datamode via Ring Line:
AT^SCFG=”URC/Datamode/Ringline”[, <udri>]
Write Responses:
^SCFG: “URC/Datamode/Ringline”, <udri>
OK
ERROR
+CME ERROR
Write Command for URC Indication via Ring Line:
AT^SCFG=”URC/Ringline”[, <uri>]
Write Responses:
^SCFG: “URC/Ringline”, <uri>
OK
ERROR
+CME ERROR
Write Command for Duration of Active RING Line for URC Indications:
AT^SCFG=”URC/Ringline/ActiveTime”[, <urat>]
Write Responses:
^SCFG: “URC/Ringline/ActiveTime”, <urat>
OK
ERROR
+CME ERROR
Unsolicited Result Codes:
^SYSSTART AIRPLANE MODE
This URC is issued each time the Airplane mode is activated, no matter whether Airplane mode is set with
parameter <map>="on" or <mapos>="on". The URC notifies the user that only the AT commands supported in
Airplane mode are accessible. After leaving the Airplane mode the URC "^SYSSTART" indicates that the ME
has returned to Normal mode and the full set of AT commands is accessible again.
Parameter Descriptions:
<gs0aa> GPRS ATS0 with Attach
This parameter can be used to control the behaviour of ATS0.
Parameter is global for all interfaces, volatile and will not be reset by AT&F.
“on“ When ATS0=<n> (<n>>0) is received, the MT will attempt to perform a GPRS attach. This is the
powerup default value of this parameter.
“off“ When ATS0=<n> (<n>>0) is received, the MT will not attempt to perform a GPRS attach.
<gaa> GPRS with Auto Attach
This parameter can be used to control whether the ME will perform a GPRS attach immediately after
registering to the network or not. If the setting is changed to “enabled” and the ME is not attached yet, it will
not initiate an attach immediately but after the next registration to the network.
Parameter is global for all interfaces, non volatile and will not be reset by AT&F.
“disabled“ GPRS auto attach is disabled. Default.
“enabled“ GPRS auto attach is enabled.