Specifications

Chapter 2 – Configuration Commands
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 21
2.5 ATV Set Result Code Format Mode
Description: This command determines the contents of the header and trailer transmitted with AT
command result codes and information responses. Possible responses are described in
Section 2.5.1, Verbose and numeric result codes.
Store this parameter with the AT&W command.
Display this parameter with the AT&V command.
Exec Command Syntax: ATV<value>
Response: OK
ERROR
Parameter Value:
<value>
0 Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1 Information response: <CR><LF><text><CR><LF> Long result code format:
<CR><LF><verbose code><CR>
2.5.1 Verbose and Numeric Result Codes
Verbose format Numeric format Meaning
OK 0 Command executed, no errors
CONNECT 1 Link established
RING 2 Ring detected
NO CARRIER 3 Link not established or disconnected
ERROR 4 Invalid command or command line too long
NO DIALTONE 6 No dial tone, dialing impossible, wrong mode
BUSY 7 Remote station busy
CONNECT 2400/RLP 47 Link with 2400 bps and Radio Link Protocol
CONNECT 4800/RLP 48 Link with 4800 bps and Radio Link Protocol
CONNECT 9600/RLP 49 Link with 9600 bps and Radio Link Protocol
CONNECT 14400/RLP 50 Link with 14400 bps and Radio Link Protocol
ALERTING Alerting at called phone
DIALING Mobile phone is dialing