Specifications

Chapter 2 – Configuration Commands
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 20
2.2.1 AT&V Responses
The following table shows different kinds of responses depending on whether or not the PIN is entered.
Table 2.1: Current configuration on ASC0 channel 1 (example)
PIN authentication done No PIN authentication
ACTIVE PROFILE:
E1 Q0 V1 X4 &C1 &D2 &S0 \Q0 \V1
S0:000 S3:013 S4:010 S5:008 S6:000 S7:060 S8:000
S10:002 S18:000
+CBST: 7,0,1
+CRLP: 61,61,78,6
+CR: 0
+FCLASS: 0
+CRC: 0
+CMGF: 0
+CSDH: 0
+CNMI: 0,0,0,0,1
+IFC:3
+IFC:0,0
+ILRR: 0
+IPR: 115200
+CMEE: 2
^SMGO: 0,0
+CSMS: 0,1,1,1
^SACM: 0,”000000”,”000000”
^SLCC: 0
^SCKS: 0,1
^SSET:0
+CREG: 0,1
+CLIP: 0,2
+CAOC: 0
+COPS: 0,0,”operator”
+CGSMS: 3
OK
ACTIVE PROFILE:
E1 Q0 V1 X4 &C1 &D2 &S0 \Q0 \V1
S0:000 S3:013 S4:010 S5:008 S6:000 S7:060 S8:000
S10:002 S18:000
+CBST: 7,0,1
+CRLP: 61,61,78,6
+CR: 0
+FCLASS: 0
+IFC:3
+IFC:0,0
+ILRR: 0
+IPR: 115200
+CMEE: 2
^SCKS: 0,1
^SSET:0
OK
Note: Table 2.2 has been intentionally omitted.
2.3 AT&W Stores Current Configuration
Description: AT&W stores the currently parameters to a user-defined profile in the non-volatile
memory.
Exec Command Syntax: AT&W[value]
Response: OK
Parameter Values:
<value>
0 Number of the profile
Notes:
• The user defined profile will be restored automatically after power-up. Use ATZ to restore user profile and AT&F
to restore factory settings. Until the first use of AT&W, ATZ works as AT&F.
• User defined profiles in multiplex mode:
AT&W stores all global settings and the current settings of the interface on which the command is executed.
• A list of parameters stored to the user profile can be found in Section 20.5, AT Command Settings storable with
AT&W.
2.4 ATQ Set Result Code Presentation Mode
Description: This parameter setting determines whether or not the TA transmits any result code to the
TE. Information text transmitted in response is not affected by this setting.
Store this parameter with the AT&W command.
Display this parameter with the AT&V command.
Exec Command Syntax: ATQ<n>
Response: If <n> = 0, then OK. Default
If <n> = 1, then (none).
Parameter Values:
<n>
0 DCE transmits result code. Default.
1 Result codes are suppressed and not transmitted