Specifications

Chapter 11 – GPRS Commands
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 154
<Traffic handling priority>
This parameter specifies the relative importance for handling of all SDUs belonging to the UMTS bearer
compared to the SDUs of the other bearers.
0 subscribed. Default
1
2
3
<PDP_type>
Packet Data Protocol Type
“IP“
Notes:
• If parameters are not defined, the parameter default values depend on the HLR-stored subscribed default values.
• Definitions of parameters can be found in 3GPP TS 23.107
11.9 AT+CGPADDR Show PDP Adress
Description: The test command returns a list of defined <cid>s.
The write command returns a list of PDP addresses for the specified context identifiers. If no
<cid> is specified, the addresses for all defined contexts are returned.
Test Command Syntax: AT+CGPADDR=?
Response: [+CGPADDR: (list of defined <cid>s)]
OK
Write Command Syntax: AT+CGPADDR=[<cid>[,<cid>]]
Response: [+CGPADDR: <cid>, <PDP_address>]
[+CGPADDR: <cid>, <PDP_address>]
OK
ERROR
+CME ERROR
Parameter Descriptions:
<cid>
A numeric parameter which specifies a particular PDP context definition (see AT+CGDCONT command).
<PDP_address>
A string that identifies the MT in the address space applicable to the PDP. The address may be static or
dynamic.
Note:
If no <cid> is specified, the write command will return a list of all defined contexts.