Specifications

Chapter 10 – Internet Service Commands
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 139
10.5.1 Example: Socket Host Reads Small Amounts of UDP Data Packets
This section applies only to the Socket service using the UDP protocol. The example shows how to read UDP
packets if the buffer of the host application can handle only a few bytes. There are two datagrams available for
reading.
Buffer size: 6 bytes
Datagram A = 18 bytes (content "THIS_IS_DATAGRAM_A")
Datagram B = 3 bytes (content "NEW")
^SISR: 0,1 Service profile 0 is configured for Socket service and UDP. The URC notifies host that data
are available for reading.
at^sisr=0,6 The host requests to read 6 bytes.
^SISR: 0,6,12 The first 6 bytes of datagram A are confirmed and transmitted. Another 12 bytes are still
THIS_I available.
OK
at^sisr=0,6 The host requests to read the next part of 6 bytes.
^SISR: 0,6,6 The next 6 bytes of datagram A are confirmed and transmitted. Another
S_DATA 6 bytes are still available.
OK
at^sisr=0,6 The host requests to read the next part of 6 bytes.
^SISR: 0,6,0 Last part of datagram A was received, no remainder is left.
GRAM_A
OK
at^sisr=0,6 Again, the host requests to read 6 bytes. This time, the URC refers to datagram B which
has only 3 bytes. As the read datagram is smaller than the size requested by the host, the
URC does not include the <remainUdpPacketLength>.
^SISR: 0,3 3 bytes are confirmed and transmitted. Datagram B was properly received.
NEW
OK