Specifications

CUSTOMATCOMMANDS


235 HSPA+ATCommandsReferenceGuide

OK

Givethecommandspecifyingtotalnumberofbytesassecondparameter:
at#ssendext=1,256
> .............................. ; // Terminal echo of bytes sent is displayed here
OK
Allpossiblebytes(from0x00to0xFF)aresentonthesocketasgenericbytes.
IPStackAuthentication Type#SGACTAUTH
SetcommandsetstheauthenticationtypeforIPStack
ThiscommandhaseffectontheauthenticationmodeusedonAT#SGACTorAT#GPRScommands.
ReadcommandreportsthecurrentIPStackauthenticationtype,intheformat:
#SGACTAUTH:<type>
Testcommandreturnstherangeofsupportedvaluesforparameter<type>.
Syntax
Command Commandtype
AT#SGACTAUTH=<type> Set
AT#SGACTAUTH? Read
AT#SGACTAUTH=? Test
ParametersandValues
<type> 
0 Noauthentication.
1 PAPauthentication.Default:1.
2 CHAPauthentication.
Notes
 TheparameterisnotsavedinNWM(Non‐volatilememorynon‐volatilememory).
ContextActivationandConfiguration#SGACTCFG
Executecommandenablesordisablestheautomaticactivation/reactivationofthecontextforthespecifiedPDP
context,tosetthemaximumnumberofattemptsandtosetthedelaybetweenanattemptandthenextone.The
contextisactivatedautomaticallyaftereveryGPRSAttachorafteraNWPDPCONTEXTdeactivationifatle
astone
socketisconfiguredtothiscontext.SeeAT#SCFG.
Readcommandreportsthestateofallthefivecontexts,intheformat:
#SGACTCFG:<cid1>,<retry1>,<delay1>,<urcmod>CR><LF>
…