Specifications


CUSTOMATCOMMANDS

HSPA+ATCommandsReferenceGuide 196

Notes
 Thevaluesarestoredinnon‐volatilememoryandavailableonfollowingreboot.
 Forpossible<encGSM>encryptionsseetestcommandresponse.
Examples
AT#ENCALG?
#ENCALG: 5,2,1,1
OK
AT#ENCALG=5,1
OK

SetstheGSMencryption algorithm A5/1andA5/3,andtheGPRSencryptionalgorithmGEA1.Itisavailableatthe
nextreboot.

AT#ENCALG?
#ENCALG: 5,2,1,1

ThelasttwovaluesindicatethatthelastusedGSMencryptionalgorithmisA5/1andthelastusedGPRS
encryptionalgorithmisGEA1.
Afterreboot
AT#ENCALG?
#ENCALG: 5,1,1,1
ATRunCommands
EnableSMSRunATService#SMSATRUN
SetcommandenablesordisablestheSMSATRUNservice.
Readcommandreturnsthecurrentsettingsof<mode>andthevalueof<stat>intheformat:
#SMSATRUN:<mod>,<stat>
where:
<stat> Servicestatus.
0 Notactive.
1 Active.
TestcommandreturnsthesupportedvaluesfortheSMSATRUNparameters.
Syntax
Command Commandtype