Specifications


CUSTOMATCOMMANDS

HSPA+ATCommandsReferenceGuide 170

Testcommandtestsforcommandexistence.
Syntax
Command Commandtype
AT#CPBD Execute
AT#CPBD=? Test
ATDDialingMode#DIALMODE
Setcommandsetsdialingmodality.
ReadcommandreturnscurrentATDdialingmodeintheformat:
#DIALMODE:<mode>
Testcommandreturnstherangeofvaluesforparameter<mode>
Syntax
Command Commandtype
AT#DIALMODE=[<mode>] Set
AT#DIALMODE? Read
AT#DIALMODE=? Test
ParametersandValues
<mode> 
0
Voicecallonly.OKresultcodeisreceivedassoonasitstartsremotelyringing.
Default:0.
1
Voicecallonly.OKresultcodeisreceivedonlyafterthecalledpartyanswers.Any
charactertypedabortsthecallandOKresultcodeisreceived.
Notes
 IfaBUSYtoneisreceivedwhenATX0isenabledATDreturnsNOCARRIERinsteadofDISCONNECTED.
 <mode>settingissavedinnon‐volatilememoryandavailableafterreboot.
AutomaticCall#ACAL
Setcommandenablesordisablestheautomaticcallfunction.
Readcommandreportswhethertheautomaticcallfunctioniscurrentlyenabledornot,intheformat:
#ACAL:<mode>
Note:Withtheintroductionofthecommand#ACALEXT(Extende dAutomaticCall)itispossiblethattheRead
Commandreturnsavaluesupportedby#ACALEXTbu
tNOTsupportedby#ACAL.
AT#ACAL?
#ACAL : 2
OK
Assuch,itisstronglyrecommendedthatyoudonottousebothcommandsatthesametime.
Testcommandreturnsthesupportedrangeofvaluesfor<mode>.