User guide

Chapter 4 - RouteFinder Software
MTASR2-203 37
The WAN Port Setup Advanced tab contains options which control message printing and script
printing, modem type control, and ISDN TA control.
The Message Printing Control group allows you to enable items that you want to be displayed on
console messages. These messages can be useful as diagnostic and troubleshooting tools but should
remain disabled (unchecked) under normal circumstances to avoid possible degradation of router
performance.
The Script Printing group allows script printing on the WAN 2 port during non-critical periods and
during alarm situations. Both these features are enabled by default. A list of Script commands by
function and an example of a typical script is found in Appendix B - Script Commands.
The Modem Control group applies only to WAN 2 and allows you to select a new modem from the
drop-down list. Add, Edit, and Delete buttons allow you to add new modems, make changes to existing
modems, or remove an existing modem from the list.
The ISDN TA Control group applies only to WAN 2 and allows to select commonly used, pre-
configured ISDN configurations from the drop-down list. Add, Edit, and Delete buttons allow you to add
a new ISDN configuration, make changes to an existing configuration, or remove an ISDN
configuration from the list.