User guide

RouteFinder-T1 User Guide
MTASR2-20314
Introduction
This chapter includes safety warning information and guides you through the unpacking and
installation of your RouteFinder. The installation procedure, provides step-by-step instructions on
cabling and powering-on your unit. Chapter 3 provides instructions on loading and configuring the
software.
Unpacking
The shipping box contains the RouteFinder, external power supply, command port adapter cable (short
cable with RJ-45 on one end and DB9 on the other), one RJ-48 cable for T1 DSU connection, your
Quick Start Guide, and one CD-ROM with RouteFinder-T1 Install Software and MTASR2-203 User
Guide. Inspect the contents for signs of any shipping damage. If damage is observed, do not power up
the unit; contact Multi-Tech’s Technical Support for advice (refer to Chapter 6). If no damage is
observed, place the RouteFinder in its final location and perform the Cabling Procedure.
MADE IN U.S.A
MADE IN U.S.A
www.multitech.com
Figure 2-1. Unpacking
Safety Warnings
1. Never install telephone wiring during a lightning storm.
2. Never install a telephone jack in wet locations unless the jack is specifically designed for wet
locations.
3. This product is to be used with UL and cUL listed PCs.
4. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
5. Use caution when installing or modifying telephone lines.
6. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
7. Do not use a telephone in the vicinity of a gas leak.
8. To reduce the risk of fire, use only 26 AWG or larger telecommunication line cord.