User guide

Cabling

Changing Shunt Position

Table 2 provides the procedure for moving the WAN link shunt

when the RouteFinder is being connected to an external composite

link device with a V.35 interface.

Table 2. V.35 Shunt Procedure

Step Procedure

1. Ensure that the external power supply is disconnected

from the RouteFinder.

2. Turn the unit upside down and remove the cabinet

mounting screw at the center back of the cabinet. See

Figure 4.

Cabinet

Mounting

Screw

ETHERNET FAIL

POWER

RCV

XMT

COL

LNK

RCV

XMT

CTS

RTS

ERR

PWR

Systems

WAN LINK

V35

Figure 4. Cabinet Mounting Screw

3. Turn the unit right side up, then slide the base out the rear

of the cabinet.

4. Position the base so the front panel LEDs are toward you,

as in Figure 5.

RS232

Shunt Position

V.35

Shunt Position

Figure 5. V.35 Shunt