User guide

RouteFinder MTASR1-100 Quick Start Guide
8
Table 1. Cabling Procedure
Step Procedure
1. If the WAN link needs to be changed to a V.35 interface,
perform the procedure in Table 2.
2. Connect the RouteFinder Command Port to your PC using
the short RJ-45 to DB25 (female) cable provided with your
unit.
Plug the RJ-45 end of the cable into the Command Port on
the RouteFinder. Plug the other end into a COM port on
the PC. See Figure 3.
3. Connect an RJ-45 (UTP) cable to the 10BaseT connector
on the back panel or a BNC (thin coaxial cable) connector
to the 10Base2 connector.
4. Connect an RS232C/D or V.35 interface cable to the back
panel RS232/V.35 connector as shown in Figure 3.
Connect the other end of the cable to the appropriate
connector on the external link device.
5. Connect one end of the power supply to a live AC outlet,
then connect the other end to the POWER connector on
the RouteFinder as shown in Figure 3. The power
connector is a 6-pin circular DIN connector.
6. Turn on power to the RouteFinder by setting the ON/OFF
switch on the back panel to the ON position.
At this time your RouteFinder is completely cabled and
powered On. Proceed to the next section to load the
RouteFinder software.