Specifications

PART 3 – Analog SocketModems Chapter 10 – SocketModem (MT5692SMI)
Multi-Tech Systems, Inc. Universal Socket Hardware Guide for Developers (S000342P) 165
IIR – Interrupt Identifier Register
(Addr = 2)
The Interrupt Identifier Register (IIR) identifies the existence and type of up to five prioritized pending interrupts.
Four priority levels are set to assist interrupt processing in the host. The four levels, in order of decreasing
priority, are Highest: Receiver Line Status, 2: Receiver Data Available or Receiver Character Timeout. 3: TX
Buffer Empty, and 4: Modem Status.
When the IIR is accessed, the modem freezes all interrupts and indicates the highest priority interrupt pending
to the host. Any change occurring in interrupt conditions are not indicated until this access is complete.
Bits 7-6 FIFO Mode
These two bits copy FCR0.
Bits 5-4 Not Used
Always 0.
Bits 3-1 Highest Priority Pending Interrupt
These three bits identify the highest priority pending interrupt (Table below). Bit 3 is
applicable only when FIFO mode is selected; otherwise, bit 3 is a 0.
Bit 0 Interrupt Pending
When this bit is a 0, an interrupt is pending; IIR bits 1-3 can be used to determine the source
of the interrupt. When this bit is a 1, an interrupt is not pending
Interrupt Sources and Reset Control Table
Interrupt Identification Register
Interrupt Set and Reset Functions
Bit 3
(Note 1)
Bit 2
Bit 1
Bit 0
Priority
Level
Interrupt Type
Interrupt Source
Interrupt Reset
Control
0
0
0
1
—
None
None
—
0
1
1
0
Highest
Receiver Line
Status
Overrun Error (OE)
(LSR1),
Parity Error (PE)
(LSR2),
Framing Error (FE)
(LSR3),
or Break Interrupt (BI)
(LSR4)
Reading the LSR
0
1
0
0
2
Received Data
Available
Received Data
Available (LSR0)
or RX FIFO Trigger
Level (FCR6-FCR7)
Reached
1
Reading the RX
Buffer or the RX
FIFO drops
below the Trigger
Level
1
1
0
0
2
Character Timeout
Indication
1
The RX FIFO
contains at least 1
character and no
characters have
been removed from
or input to the RX
FIFO during the last
4 character times.
Reading the RX
Buffer
0 0 1 0 3 TX Buffer Empty TX Buffer Empty Reading the IIR
or writing to the
TX Buffer
0
0
0
0
4
Modem Status
Delta CTS (DCTS)
(MSR0),
Delta DSR (DDST)
(MSR1),
Trailing Edge Ring
Indicator (TERI)
(MSR3), or Delta
DCD (DCD) (MSR4)
Reading the
MSR
Note: 1. FIFO Mode only.